DIMA PER FARE I FORI A FUSTI – DA 6″ A 26″

The Sparedrum Drum Drilling Layout helps to trace easily on the shells the drilling points where you will insert the lugs, snare throw-off, butt-end, air vent…
For drum shells from 6″ to 26″

How to use :
– On a rigid and flat surface, position the layout
– Position then the shell on the corresponding size, the black line should be slightly visible. This will help to check that the shell is correctly centered
– Hold still the shell in position (it must not move)
– Use a square to draw lines with right angle on each colored visual mark (the choice of the color depends on the number of lugs your shell will be composed of)
– Draw marks where your the snare throw-off and butt-end will be positionned using the graph paper sides
– To check that the lines you drew are correct, you simply need to return the shell and check the squareness of the lines using your square angle
– Once all the vertical lines traced, you need to trace horizontal lines to finalize the drilling points according to the size of your hardware

Our advice:
– Before drilling, check several time your work
– Check that you are using the right drills (right diameter, adapted to the shell material)
– Measure and check carefully the dimensions and center to center dimensions of the hardware you want to install

Great drum building!

FUSTI GREZZI VARIE ESSENZE E SPESSORI
PER UN PREVENTIVO PERSONALIZZATO CONTATTACI
info@percussion-village.it